View source for Template:ARPI600 User Manual/How to perform wireless transmission with XBee


==How to perform wireless transmission with XBee==
Before performing the wireless transmission with XBee, please make sure the wireless network built by two XBee modules is work properly.
# Set the jumpers on ARPI600:
#: Here, we should use two Raspberry Pi boards: Raspberry Pi-A and Raspberry Pi-B, of which Raspberry Pi-A is used for transmitting data and Raspberry Pi-B is used for receiving data. 
#: Connect Raspberry Pi-A to the serial port of XBee-A and Raspberry Pi-B toXBee-B, respectively. And then, set the jumpers on ARPI600, as the shows. 
#* Connect XB_RX to P_TX
#* Connect XB_TX to P_RX
#: Setting jumpers on ARPI600
#: [[File:ARPI600-UserManual-14.jpg]]
# Testing the serial port:
#: Copy the file program/Xbee/getdata to the Raspberry Pi-B, and enter the folder getdata.
#: Then, execute the code:sudo makesudo ./serialTest
#: The relative data will be displayed as followed.
#: Displaying the message getdata
#: [[File:ARPI600-UserManual-15.jpg]]
# Run the code for transmitting data on Raspberry Pi-A. Then, copy program/Xbee/send into the Raspbian, and enter the folder send to execute the following code:sudo makesudo ./serialTest
#: You will see the following message displayed in the PuTTY of Raspberry Pi-B.