Template:Modbus RTU Relay Manual

Hardware testing

• Connect USB to 485 moduble to Modbus RTU Relay board by wires. Connect A to A and B to B. Then connect the USB to 485 module to your PC

• Download the SSCOM software and Open it in your PC. Select the correct COM port (according to Devices Manager), set baud rate to 9600. Click Extension and send the commands to test

If you want to send other commands, please check HEX option and choose ModbusCRC16 parity. Input the commands and send.

For more details of the commands, please refero Protocol Manual of Modbus RTU Relay

Examples

Raspberry Pi

Enable Serial port

• Open terminal of Raspberry Pi
• Run the following command to configure

sudo raspi-config

• Choose Interfacing Options -> Serial -> No -> Yes
• Then reboot Raspberry Pi

sudo reboot

Hardware connection

You need to connect and RS485 devices to Raspberry Pi (the demo codes provided is based on our RS485 CAN HAT), Connect Modbus RTU Relay module to the RS485 CAN HAT, A to A and B to B.

Run example

Use the following commands to run the demo codes wget https://wiki.diustou.com/w/upload/f/f9/Modbus_RTU_Relay_Code.zip unzip Modbus_RTU_Relay_Code.zip cd Modbus_RTU_Relay_Code/Python3 sudo python3 main.py

STM32

The Demo codes for STM32 is based on NULCEO-F103RB and RS485 CAN Shield module Download the #demo codes and open the STM32 project by Keil software. Program the codes to NUCLEO board The codes will run and toggle the relay in turn.

Arduino

The Arduino demo is based on Waveshare UNO Plus and RS485 CAN Shield Open Arduino project and program it to the UNO board.

The codes will run and toggle the relay in turn.