Difference between revisions of "STLINK-V3MINI"
From Diustou Wiki
m (Text replacement - "Infobox item" to "Product") |
m (Text replacement - "\{\{Amazon \|More.*More\]\}\}" to "") |
||
Line 10: | Line 10: | ||
The STLINK-V3MINI also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART. | The STLINK-V3MINI also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART. | ||
The STLINK-V3MINI is a portable version, easy-to-use debugger/programmer including STDC14 interface with its flat cable. | The STLINK-V3MINI is a portable version, easy-to-use debugger/programmer including STDC14 interface with its flat cable. | ||
− | + | ||
− | |||
==User guide== | ==User guide== |
Revision as of 09:41, 22 March 2021
| |||||||||||||||||||
|
Contents
Introduction
The STLINK-V3MINI is stand-alone debugging and programming mini probe for STM32 microcontrollers. The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board. The STLINK-V3MINI also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART. The STLINK-V3MINI is a portable version, easy-to-use debugger/programmer including STDC14 interface with its flat cable.
User guide
Supports devices
All products of STM32 series which has JTAG/SWD interface
Hardware connection
- Connect STLINK-V3MINI to host PC
- Connect micro USB interface of STLINK-V3MINI, generally, it driver will be auto installed by ST-Link tool.
- You can check the programmer is recognized by PC
- Sometimes, the driver may not be installed properly, you can also install it manually.
- Download it from the #Resources
- Right-click ST-Link Debug, and ST-Link VCP Ctrl to update the driver.
- Connect the programmer to the target board
- Connect the STLINK-V3MINI to JTAG/SWD interface of STM32 board by adapter boards
Software setting
- Connect the programmer to the target board and power on it. If all the connections are normally, you can read the information of the target board
- Then you can compile and program target board by the STLINK-V3MINI
Resources
Support
|