Difference between revisions of "Experiment 1: Traffic Light Experiment"
From Diustou Wiki
Yousimaier17 (talk | contribs) (Created page with "*Basic Experiment Kits For Arduino *Basic Experiment Kits For Raspberry Pi == Arduino == === Experimental Phenomenon === *The green light is on for 5 seconds, then tur...") |
Yousimaier17 (talk | contribs) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 40: | Line 40: | ||
== Raspberry Pi == | == Raspberry Pi == | ||
=== Circuit Connection === | === Circuit Connection === | ||
| − | + | *[[File:实验一：交通灯实验_接线2.png|600px]] | |
=== Program Execution === | === Program Execution === | ||
Latest revision as of 13:56, 11 February 2025
Contents
Arduino
Experimental Phenomenon
- The green light is on for 5 seconds, then turns off, the yellow light flashes 3 times in a loop, the red light is on for 5 seconds, and the sequence repeats.
Circuit Connection
Reference Program
int red = 2; //Define pin 2 as the interface
int yellow = 3; //Define pin 3 as the interface
int green = 4; //Define pin 4 as the interface
void setup()
{
pinMode(red,OUTPUT); //Set the red light pin as an output interface
pinMode(yellow,OUTPUT); //Set the yellow light pin as an output interface pinMode(green,OUTPUT); //Set the green light pin as an output interface }
void loop()
{
digitalWrite(green,HIGH); //Turn on the green light
delay(5000); //Delay for 5 seconds
digitalWrite(green,LOW); //Turn off the green light
for(int i=0;i<3;i++) //Flash the yellow light three times alternately
{
delay(500); //Delay for 0.5 seconds
digitalWrite(yellow,HIGH); //Turn on the yellow light
delay(500); //Delay for 0.5 seconds
digitalWrite(yellow,LOW); //Turn off the yellow light
}
delay(500); //Delay for 0.5 seconds
digitalWrite(red,HIGH); //Turn on the red light
delay(5000); //Delay for 0.5 seconds
digitalWrite(red,LOW); //Turn off the red light
}
Raspberry Pi
Circuit Connection
Program Execution
Python
- Install the gpiozero library
- You can use the following commands to install the library:
sudo apt update sudo apt install python3-gpiozero
- For other systems on the Raspberry Pi, you can use the following command to install the library:
sudo pip3 install gpiozero
- Run the following command to view the GPIO pin definitions on the Raspberry Pi:
pinout
- Download the Raspberry Pi reference examples, unzip the file, copy it to your user directory, and run:
cd raspberrypi/1/python_gpiozero python led.py
- You should now see the Raspberry Pi running a traffic light program. To exit, press ctrl+C.
- Command explanation: gpiozero.TrafficLights(red, amber, green, _options)
- Main parameters:
- red: The GPIO pin connected to the red LED
- amber: The GPIO pin connected to the amber LED
- green: The GPIO pin connected to the green LED
- pwm:
- If True, constructs PWMLED instances to represent each LED.
- If False (default), constructs regular LED instances.
- initial_value:
- If False (default), all LEDs are initially off.
- If "None", all LEDs are in an unstable initial state.
- If True, all LEDs are initially on.
- For more commands, please refer to the gpiozero documentation
